QuickJack Crossbeam Adapter

Different vehicles may have staggered or uneven lifting points, and many trucks might have kicked frame rails which can sometimes make lifting your vehicle with a QuickJack a bit of a challenge. The Crossbeam Adapter Set will be able to give your QuickJack some of the capabilities of a two-post lift by allowing you to position contact pads directly under even the most staggered lifting points around. You could easily and safely lift your car with your QuickJack places sideways, but it’s possible that it might obstruct your undercarriage, which can make some maintenance difficult or impossible to perform. The Crossbeam Adapter Set can be used to reach all of your recommended lifting points while your undercarriage remains completely free!

The Crossbeam Adapter Set fits securely in the lifting trays of each QuickJack frame and has a rail for special contact pads to slide along, making it simple to find the correct lifting points on any car or truck. The lower feet placed in the QuickJack trays are also able to slide effortlessly along the crossbeam, which will allow you to position your QuickJack frames as near or far as you want, up to its 65” length. The Crossbeam adapter set even adds 4.75” clearance height, giving you a little more elbow room when you’re working underneath.

This set comes complete with the crossbeam adapter, two easy-slide adapter pads, and two extended-length rear contact pads that can match the additional height of the crossbeam. This set comes loaded with everything you need to adapt your QuickJack to meet any situation.

What’s the difference between the Cross Beam Adapter for the BL-5000 series vs. the BL-7000 series?

The main difference between the two versions is the height of the lift adapter pads. The BL-7000 series lifting trays are a bit deeper than the BL-5000 series trays, and QuickJack has made the lift adapters slightly taller to accommodate. All other specifications are exactly the same.